Figure 8-2 Connecting The D Term Headset Cordless Base Unit To The Adapter - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
2.2
System Hardware Manual
Be sure that the base antenna can be fully extended.
The base can be placed on a desk or tabletop or mounted on a standard
telephone wall plate.
Charge your new telephone for 15~20 hours before completing the installation
or using the handset.
Connecting the Base Unit
1. Connect the AC adapter to the DC IN 9 V jack and to a standard 120V
AC wall outlet.
Route the cord
To AC Outlet
Figure 8-2 Connecting the D
2. Set the base on a desk or tabletop, and place the handset in the base
unit as shown.
3. Raise the antenna to a vertical position.
Make sure the status LED is On. When the LED is Off, check to see that
the AC adapter is plugged in and that the handset makes good contact
with the base charging contacts.
Use only the supplied AC adapter (730627).
Connect the AC adapter to a continuous power supply.
Place the base unit close to the AC outlet so you can unplug the AC
adapter easily.
To DC IN 9V
AC Adapter
(supplied)
term
Headset Cordless Base Unit to the Adapter
Issue 1.0
8 - 3