Issue 1.0
6 - 102
5.
Install the Compact Flash drive into slot CN7, make sure the
drive is fully seated in the slot (refer to
Compact Flash
6.1.3
LED Indications
6.1.3.1
Active LED – Green
The Active LED is controlled by the DSP and indicates the
board operational status.
Figure 6-36 Install the SO-DIMM Memory
Drive).
Figure 6-37 Install the Compact Flash Drive
Off: Power off.
On: Reset.
Slow Flash: Board is running but not in sync with the
chassis yet.
Fast Flash: Board is in sync with the chassis and
operating normally.
Installing the SV8100/SV8300 Blades
UNIVERGE SV8100/SV8300
Figure 6-37 Install the