Issue 1.0
4 - 30
3.5.4.1
Connector Pin-Out on the PZ-BS10/PZ-BS11
Table 4-3 PZ-BS10/PZ-BS11 Connector Pin-Out
PZ-BS10 – CN2, CN3, CN 4
3.5.4.2
Install the PZ-BS10 Expansion Base Blade in the
CHS2U-US Controlling Chassis
1.
Ensure the chassis is powered down.
2.
Locate the door positioned on the left end
(expansion bay) of the Controlling Chassis.
Figure 4-28 PZ-BS10 Expansion Bay in Controlling Chassis
UNIVERGE SV8100/SV8300
RJ-61 Cable Connector
PZ-BS11 – CN3
Pin No.
1
2
3
4
5
6
7
8
Do not remove or install this blade with
the power on.
Expansion Bay
Installing the SV8100 Chassis
Connection
HW_UP (+)
HW_UP (-)
HW_DWN (+)
FS (+)
FS (-)
HW_DWN (-)
CK8M (+)
CK8M (-)