UNIVERGE SV8100/SV8300
System Hardware Manual
2.
Mark and drill the six holes required for a wall installation.
Drilling:
a.
Make a preliminary hole in the concrete, using a drill bit for
small-diameter holes.
b.
Drill a hole in the concrete with a drill suitable for a plug bolt a
little deeper than the plug bolt length.
Anchor Bolt Size:
0.39" (10mm) DIA for Fixed Equipment
0.24" (6mm) DIA for Stationary Equipment
c.
Insert the anchor bolt into the hole.
d.
Push anchor bolt unit the bolt stays permanently in place.
e.
Turn bolt counterclockwise and remove.
f.
Insert bolts correctly into the holes for equipment installation,
then tighten them properly.
a
b
Figure 5-6 Drilling Instructions for Anchor Bolt
3.
Align screw holes in wall mount brackets with pre-drilled holes
in wall.
d
c
Issue 1.0
e
f
5 - 9