NEC Univerge SV8100 System Hardware Manual page 324

Issue 1.0
6 - 12
After reloading the customer data to the system, exit
programming mode (this could take a minute or more to
save the database), then reset the system by powering
down and back up. If the system is not reset, not all the
uploaded programming changes are in effect. Wait a few
minutes for the programming to take affect before accessing
any line or special system feature. Otherwise, some unusual
LED indications may be experienced. To prevent the USB
Memory from possibly being overwritten, remove the card
after reloading the database.
2.6.4 Performing a Software Upgrade
This section describes the procedure to perform a software upgrade
on the CD-CP00-US.
To save customer data prior to updating, a blank USB
Memory is required. Insert the USB Memory into the
USB Port on the CD-CP00-US blade. Use Program
90-03 to save the software to the USB Memory. Note that
a USB Memory can only hold one customer database.
Each database to be saved requires its own separate USB
Drive. Use Program 90-04, with the database to be
restored installed in the CD-CP00-US, to reload the
customer data if necessary.
After uploading programming data to the system using
Program 90-04, exit programming mode (this could take
a minute or more to save the database), then reset the
system by powering down and back up. Wait a few
minutes for the programming to take affect before
accessing any line or special system feature. Otherwise
some unusual LED indications may be experienced. To
prevent the USB Memory from possibly being
over-written, remove the USB Memory after downloading
the database.
When restoring a database file, as the slot definitions
may be different, remove all blades from the system
except the CD-CP00-US and CD-8DLCA/CD-16DLCA in
slot 2. After the system has been reset, the blades can be
reinstalled. Use Program 10-03 prior to updating to
record the current slot definitions.
IMPORTANT CONSIDERATIONS
Installing the SV8100/SV8300 Blades
UNIVERGE SV8100/SV8300