UNIVERGE SV8100
System Hardware Manual
5.
Install the Compact Flash drive into slot CN7, make sure the
drive is fully seated in the slot (refer to
Compact Flash
6.1.3
LED Indications
6.1.3.1
Active LED – Green
The Active LED is controlled by the DSP and indicates the
board operational status.
Figure 4-39 Install the SO-DIMM Memory
Drive).
Figure 4-40 Install the Compact Flash Drive
Off: Power off.
On: Reset.
Slow Flash: Board is running but not in sync with the
chassis yet.
Fast Flash: Board is in sync with the chassis and
operating normally.
Issue 2.0
Figure 4-40 Install the
4 - 97