Table 4-2 Adding Daughter Board To Chassis Example; Order Of Installing Trunk Blades - NEC Univerge SV8100 System Hardware Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

System Hardware Manual

Table 4-2 Adding Daughter Board to Chassis Example

Initial Blade

(no daughter

The system automatically recognizes each blade installed in the

system. If a blade was installed previously in a slot and another type

of blade is to be installed in that same slot, the blade must first be

removed from the chassis and then the slot definition removed using

Program 90-05 prior to installing the new blade.

This same condition applies to extensions and other devices

connected to the system. For example, if a port was used previously

for a telephone and a DSS Console is to be installed in that same

port, the telephone must be undefined in Program 10-03 before the

console is connected.

Installing CD-4COTB, CD-4DIOPA, CD-4ODTA or

CD-2BRIA Blades

The order in which trunk blades are physically inserted

determines the numbering plan.

To avoid unexpected extension/trunk

numbering if the VoIP or Voice Mail

daughter board registers with the system

first, install these boards after the other

extension and trunk blades are installed.

Updated Blade

(with daughter