NEC Univerge SV8100 System Hardware Manual page 263

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

System Hardware Manual

When restoring a database file, as the slot definitions may

be different, remove all blades from the system except the

CD-CP00-US and the CD-8DLCA/CD-16DLCA in slot 2.

After the system is reset, blades can be installed again.

Program 10-03 or Program 90-04 can be used prior to

updating to record the current slot definitions. If the blades

are not removed, the trunk and extension port assignments

may be reassigned, depending on which blade syncs up

with the system first.

After reloading the customer data to the system, exit

programming mode (this could take a minute or more to

save the database), then reset the system by powering

down and back up. If the system is not reset, not all the

uploaded programming changes are in effect. Wait a few

minutes for the programming to take affect before accessing

any line or special system feature. Otherwise, some unusual

LED indications may be experienced. To prevent the USB

Memory from possibly being overwritten, remove the card

after reloading the database.