Issue 2.0
11 - 16
3.3.2
Installing AP(A)-R or AP(R)-R Unit on a Multiline Terminal
The AP(A)-R or AP(R)-R Unit should be installed after the switches
are set.
When wall mounting the multiline terminal, a WM-R Unit must be used.
Refer to
1.
Prepare multiline terminal for adapter installation. Refer to
Section 2 Preparing Multiline Terminal for Adapter Installation
on page
2.
Plug the tabs marked A and B into adapter slots, then snap the
tab on the other end of the adapter into the receptacle marked
C. Refer to
the Multiline Terminal on page
Section 11 Wall Mounting Multiline Terminals on page
11-1.
Figure 11-17 Attaching the AP(A)-R/AP(R)-R Unit to
Installing D
UNIVERGE SV8100
11-17.
term
Series i Optional Equipment
10-22.