Issue 2.0
4 - 38
3.5.2
Conditions
The IPK/IPKII systems are limited to 18 total card slots.
An IPK system can support the migration card, provided the cards and
terminals are listed below as being supported. It may be necessary to
upgrade firmware as noted.
MEGACO is not supported.
Figure 4-16 SV8100 to IPK/IPK II Connection
connection layout of the SV8100 and IPK/IPK II.
IPK/IPK II
3.5.3
Installation
The MGN-U10 ETU board requires the CD-CP00-US, PZ-ME50-US
and PZ-BS10 to be installed in the controlling CHS2U-US.
CAT5 LAN Cable x 3
Maximum Length: 3' 9"
(1.2m)
Figure 4-16 SV8100 to IPK/IPK II Connection
Do not install or remove this board with the IPK/
IPK II cabinet power on.
The SV8100 should be at default state. Any
non-supported IPK II boards should be removed
at this time. Refer to
Hardware on page
4-39.
UNIVERGE SV8100
illustrates a typical
SV8100
MGN-U10 ETU
Table 4-15 IPK II Supported
Installing the SV8100 Blades