Table 8-3 Conference Max Plus Keypad Functions; Connecting And Charging The Batteries - NEC Univerge SV8100 System Hardware Manual

Issue 2.0
3.1
3.2
3.3
8 - 6
Installing the Base Unit
To install the base unit:
1. Connect the provided RJ-11 cable between the Base Unit and the
telephone jack.
2. Connect the power cord to the Base Unit and plug it in an electrical
outlet.
3. If desired, connect a recording device to the 2.5mm audio jack.

Connecting and Charging the Batteries

To connect and charge the batteries:
1. Slide the cover off the battery compartment on the bottom of one pod.
2. Connect the battery pack plug in the port in the compartment and install
the battery pack.
3. Slide the cover back in place.
4. Connect the power supply/charger to the conferencing pod and plug it in
an electrical outlet.

Charge batteries for 15 hours prior to first use.
5. Repeat steps 1~4 for the other pod.
Keypad Functions
Refer to Table 8-3 Conference Max Plus Keypad

Table 8-3 Conference Max Plus Keypad Functions

Key
ON/OFF key
(telephone icon)
PHONEBOOK (book
icon)
REDIAL (circular
arrow icon)
CONFERENCE
(three person icon)
FLASH (lightning
flash icon)
Press to activate the telephone and access dial tone.
Press again to hang up and return to standby mode.
Press to dial stored numbers. Press and hold two seconds
to enter Phonebook Edit mode.
Press once to dial the last number called. Press and hold
two seconds to enter Program mode.
Press to dial the conferencing service provider. This
feature must be programmed.
Press to enable call forwarding, call waiting, or three-way
calling when supported by telephone service.
Installing SV8100 Conference Solutions
UNIVERGE SV8100
Functions.
Function