Table 4-39 Cd-4Diopa Led Indications; Installation - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
LED Indication
Live LED Busy LED
(Green) (Red)
On On
Flash (1s) On
Flash (1s)
On
Flash
(100ms)
Off
On
Off
Off
Flash 80ms
(On/Off) x 3/
400ms Off
System Hardware Manual
The CD-4DIOPA provides:
Four (DIOPA) DID trunk circuits or four OPX circuits

Two Blade status LEDs

-48VDC

Refer to the following tables for maximum upgrade capacities of the
CD-4DIOPA blade:
Table 2-6 SV8100 Maximum 9.5" Gateway and 19" System Capacities

– Blades on page 2-13
Table 2-7 SV8100 Maximum 9.5" Base and Expansion System

Capacities – Blades on page 2-15
5.5.2

Installation

The CD-4DIOPA can be installed in any universal slot.
5.5.3 LED Indications
LED indications for the CD-4DIOPA are listed in
CD-4DIOPA LED
function and LED and Operational status. Refer to
CD-4DIOPA Blade on page 4-80
blade.

Table 4-39 CD-4DIOPA LED Indications

Operation Status
System Initializing
The assignment of the unit is refused.
Trouble found during self-diagnostics.
A Channel is busy (use
Normal
another from CH1 ~ CHx).
Operation
All channels are idle.
A Channel is busy (use
Unit Busy
another from CH1 ~ CHx).
All channels are idle.
Downloading firmware.
Indications. Each LED is listed with its associated
for the location of the LEDs on the
–
When you exceed the system
capacity.
When the main software
version is not matched.
–
–
–
–
–
–
Issue 2.0
Table 4-39
Figure 4-30
Remarks
4 - 81