NEC Univerge SV8100 System Hardware Manual page 17

UNIVERGE SV8100
___________________________________________________________________________________
Section 10 Remove and Install Cooling Fan ............................................ 3-112
Chapter 4 Installing the SV8100 Blades
Section 1
Section 2
___________________________________________________________________________________ ___________________________________________________________________________________
System Hardware Manual System Hardware Manual
10.1 CHS2U-US Chassis.................................................................. 3-112
10.1.1 Remove Cooling Fan ........................................................... 3-112
10.1.2 Install Cooling Fan .................................................................. 3-113
General Information .................................................................... 4-1
1.1 Slot Locations ............................................................................... 4-1
Installation................................................................................... 4-4
2.1 Installation and Safety Precautions ............................................ 4-4
2.2 Installing an Extension or Trunk Blade ......................................... 4-5
2.2.1 Installing the Blades.................................................................... 4-5
2.2.2 Order of Installing Extension Blades........................................... 4-6
2.2.3 Order of Installing Trunk Blades ................................................. 4-7
2.2.3.1
2.2.3.2
2.3 Remove an Extension or Trunk Blade .......................................... 4-8
2.4 Uninstalling a Blade Slot Through Software ................................. 4-9
2.5 Blade Capacities........................................................................... 4-9
2.6 Powering Up the SV8100 System ................................................ 4-9
2.6.1 Performing a Cold Start .............................................................. 4-9
2.6.2 Performing a Hot Start .............................................................. 4-10
2.6.3 Resetting the System................................................................ 4-10
2.6.3.1
2.6.3.2
2.6.3.3
Installing CD-4COTB, CD-4DIOPA, CD-4ODTA
or CD-2BRIA Blades..............................................................4-7
Installing CD-PRTA (T1/PRI) Blades.....................................4-8
Initial Programming..............................................................4-10
Port Defaults........................................................................4-11
Setting Up Extension Circuit Types .....................................4-11
Issue 2.0
- vii vii