Uninstalling A Blade Slot Through Software - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
2.4
2.5
2.6
System Hardware Manual

Uninstalling a Blade Slot Through Software

The installer can turn off (busy out) and delete (remove from software) blade
slots in the Controlling and Expansion Chassis in programming for port
renumbering or to replace it with a different blade. Deleting a blade may affect
blade slot programming ability. Refer to Program 90-05 in the UNIVERGE
SV8100 Programming Manual for detailed information.
Blade Capacities
The universal architecture of the UNIVERGE SV8100 provides flexibility
when installing blades. With the exception of the CD-CP00-US, PZ-BS10,
and PZ-BS11 blades, any blade can be installed in any slot.
SV8100 Maximum 9.5" Gateway and 19" System Capacities – Blades on page
2-13 and Table 2-7 SV8100 Maximum 9.5" Base and Expansion System
Capacities – Blades on page 2-15
maximum capacities with various chassis configurations.
Powering Up the SV8100 System
2.6.1 Performing a Cold Start
This section describes the process for starting the system (19" and
9.5" chassis) for the first time or starting a system that has been
turned off.
System software is loaded from flash memory, and the

customer data is loaded from RAM memory.
To avoid extension and trunk renumbering, if certain

blades are recognized first, remove them from their
respective slots until the system has been reset. Then,
slot the blade cards in the correct order to retain the
proper system numbering. (Use Program 10-03 prior to
performing a cold start to record the current slot
definitions.)
To perform a cold start:
1. Turn the system power off.
2. Once the system has powered down, push in and hold the
Load button.
provide a list of the blades and the
IMPORTANT CONSIDERATIONS
Issue 2.0
Table 2-6
4 - 9