UNIVERGE SV8100
LED Indication
Live LED
Busy LED
(Green)
(Red)
On
On
Flash (1s)
On
Flash (1s)
On
Flash
(100ms)
Off
On
Off
Off
Flash 80ms
(On/Off) x 3/
400ms Off
System Hardware Manual
3.
Connect the cable from the NT1 Network Termination cable to
the CN7 or CN8 connector on the CD-2BRIA blade and/or
PZ-2BRIA daughter board. (Refer to
Blade on page 4-73
blade.)
5.3.3
LED Indications
LED indications for the CD-2BRIA are listed in
LED
Indications. Each LED is listed with its associated function and
LED and Operational status. Refer to
on page 4-73
Table 4-36 CD-2BRIA LED Indications
Operation Status
System Initializing
The assignment of the unit is refused.
Trouble found during self-diagnostics.
A Channel is busy (use
Normal
another from CH1 ~ CHx).
Operation
All channels are idle.
A Channel is busy (use
Unit Busy
another from CH1 ~ CHx).
All channels are idle.
Downloading firmware.
for the location of the connectors on the
for the location of the LEDs on the blade.
Issue 2.0
Figure 4-28 CD-2BRIA
Table 4-36 CD-2BRIA
Figure 4-28 CD-2BRIA Blade
Remarks
–
When you exceed the system
capacity.
When the main software
version is not matched.
–
–
–
–
–
–
4 - 75