Table 9-4 Dt330 Compatibility Settings; Installing The Ada-L Unit - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
ADA-L Unit Switch
Settings
ADA Connection for
Recording Only.
ADA Connection for
Sending Recorded
Calls to the Telephone.
To Send and Receive
to the Terminal
Lot Numbers: I, J – Hardware Revision
Lot Numbers: L, M, S – Software Revision

To verify DT-330 terminal firmware, hold down keypad buttons 1, 2 and 3 while plugging the line cord into the terminal.
System Hardware Manual

Table 9-4 DT330 Compatibility Settings

xxx I Lx or lower
(Version 1.E0 or lower)
Dip switches 1, 2, 3, 5, 7
and 8 are OFF. Switches
4 and 6 are ON.
Dip switches 2, 3, 5, 7
and 8 are OFF. Switches
1, 4 and 6 are ON.
Not supported
12.3.2

Installing the ADA-L UNIT

Perform the following steps to connect the ADA-L UNIT to the
Bottom Option Interface located underneath the DTL/ITL multiline
terminal.
Only one ADA-L UNIT can be installed at a time.

1. Unplug the line cord from the multiline terminal.
2. Turn the DTL/ITL multiline terminal upside down.
3. Lower the tilt leg to the first position (refer to
Separate Tilt Leg from Leg Support on page
Terminal Lot Number DT-330
xxx I Mx
(Version 8.10)
Dip switches 1, 2, 3, 5, 7
and 8 are OFF. Switches
4 and 6 are ON.
Dip switches 2, 3, 5, 7
and 8 are OFF. Switches
1, 4 and 6 are ON.
Dip switches 1, 2, 3, 5, 7
and 8 are OFF. Switches
4 and 6 are ON.
To prevent possible damage to the ADA-L UNIT
or the DTL/ITL multiline terminal during
installation or removal, disconnect the line
cord/LAN cable and the AC/DC adapter from
the DTL/ITL multiline terminal.
Issue 2.0
xxxJSx or higher
(Version 2.20 or higher)
Dip switches 1, 2, 3, 5, 7
and 8 are OFF. Switches
4 and 6 are ON.
Dip switches 2, 3, 5, 7
and 8 are OFF. Switches
1, 4 and 6 are ON.
Dip switches 1, 2, 3, 5, 7
and 8 are OFF. Switches
4 and 6 are ON.
Figure 9-49
9-74).
9 - 73