NEC Univerge SV8100 System Hardware Manual page 535

UNIVERGE SV8100
System Hardware Manual
10.2.1 Connecting the Switch
Connection requires installing an AP(R)-L analog adapter (not
supplied with this unit) on the multiline terminal.
1. Connect the AC power adapter to the AC Power Adapter Jack
(indicated by a 9V icon) on the bottom of the Base, and plug
the adapter into a power source.
2. The DTR-1C-2 switch is a small rectangular unit with a line
cable on one end and a line cable and fixed cable on the other.
Connect the fixed cable to the Lifter jack (located left of the AC
Power adapter jack) on the bottom of the Base.
3. Connect the Line cord next to the fixed cable on the switch to
the Base connector on the bottom of the Base unit indicated by
a telephone icon.
4. Connect the single line on the other end of the DTR-1C-2
switch to the AP(R)-L analog adapter and connect the AP(R)-L
adapter to the telephone.
10.2.2 Charging the Headset
Slide the Headset into the charging cradle on the Base. The Amber
charging indicator blinks. When the Headset is charged, the
indicator remains on continuously. A complete charge takes three
hours.
10.2.3 Configuring the Headset to Your Telephone
When any of the following situations occurs, the Headset must be
configured to be compatible with your telephone:
Dial tone is not present.

The caller is not heard.

The caller does not hear you.

Hissing or buzzing is heard in the Headset.

To configure the Headset:
1. Lift the telephone handset.
2. Press the Talk Button.
Issue 2.0
6 - 75