Using The Psa-L Adapter - NEC Univerge SV8100 System Hardware Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

System Hardware Manual

Using the PSA-L Adapter

CAUTION: Before installing or removing the

PSA-L adapter, remove the line cord, LAN cable,

and then AC adapter from the outlet.

Placing Calls:

When the PSTN line is activated either manually by the switch

or due to a power failure, use the dial pad buttons (0-9, *, #) to

place an outside call. Use the Vol

decrease audio levels.

Other than receiving calls, no other multiline terminal

function is available.

Answering Calls:

If you receive a call via PSTN during a conversation via

LAN, answer the call by completing the LAN call and

placing the handset back into the cradle. Change the

LAN/PSTN Change Switch to PSTN and then lift the

handset to answer the call. If you change the LAN/PSTN

Change Switch to the PSTN position while talking via

LAN, the LAN call is disconnected.

Other than receiving calls, no other terminal function is

Adjusting the Ring Volume

Use the Volume Control Switch located on the PSA-L adapter

to adjust through the three available volume levels.

Other than receiving calls, no other terminal function is

When Power is Restored

The IP multiline terminal restarts and reconnects to the network

LAN. However, if you are on a PSTN call when the power is

restored, your conversation continues until the handset is

placed in the cradle. Once this occurs, the IP terminal restarts

and reconnects to the LAN.

Other than receiving calls, no other terminal function is

to increase or