Figure 6-67 Separate Tilt Leg From Leg Support; Figure 9-73 Separate Tilt Leg From Leg Support - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
System Hardware Manual
2. Unplug the line cord and handset cord from the multiline
terminal.
 Only one GBA-L UNIT can be attached to the DTL/ITL multiline
terminal.
3. Lower the tilt leg to the first position (refer to
Separate Tilt Leg from Leg
Tilt Leg

Figure 9-73 Separate Tilt Leg from Leg Support

4. Push the two stopper tabs through the slots to separate the tilt
leg from the leg support.
5. Lay the tilt leg and the leg support flat.
6. Press the two tabs locking the legs to the multiline terminal and
pull the legs toward you, lifting to remove (refer to
Remove Legs From Multiline Terminal on page
Figure 9-73
Support).
9-92).
Issue 2.0
Stoppers
Figure 9-74
9 - 91