Figure 3-89 Position The 9.5" Stand Mount Brackets; Stand Mounting The 9.5" Gateway (Chs2U Gw-Us And Base (Chs2U B-Us) Chassis - NEC Univerge SV8100 System Hardware Manual

UNIVERGE SV8100
6.2
System Hardware Manual
Stand Mounting the 9.5" Gateway (CHS2U GW-US) and Base
(CHS2U B-US) Chassis
The 9.5" chassis can be stand mounted using the brackets supplied. The
following section describes this procedure.
This bracket is not for use with a combined Base (CHS2U
B-US) and Expansion (CHS2U E) chassis. A combined
Base and Expansion chassis should only be rack or wall
mounted.
1. Lay the two bracket halves on a flat surface.

Figure 3-89 Position the 9.5" Stand Mount Brackets

2. Using the slots on the sides of the 9.5" chassis as guides, insert the
stand mount brackets into the chassis (refer to
Stand Mount Bracket
Mount Bracket on page
and Figure 3-91 Attach Remaining 9.5" Stand
3-78).
Issue 2.0
Figure 3-90 Attach 9.5"
3 - 77