Chapter 1 Multiline Terminal Programming - NEC Xen IPK Programming Manual

Preface
About this manual.
The Programming Manual was developed primarily for the technician and provides all necessary
information for programming the Xen IPK system.
Programming can be accomplished using either a PC or a Multiline Terminal.
S 1
ECTION
M
ANUAL
O
RGANISATION
S 2
ECTION
S
UPPORTING
D
OCUMENTS
Programming Manual
This manual provides instructions for programming the Xen system.
Chapter 1 – Multiline Terminal Programming
This chapter includes all of the Memory Blocks used to program the system.
Detailed programming instructions are provided for each Memory Block.
Chapter 2 – Guide to Feature Programming
This chapter includes a list by feature of the Memory Blocks necessary for
programming each feature.
Chapter 3 – PC Programming
This chapter includes the instruction or programming using Xen PC
software.
The Xen system has a set of manuals that provide all the information
necessary to install and support the system. The remaining manuals which
comprise the set are described below.
Features and Specifications Manual
This manual provides detailed information related to every feature available
in the system.
System Hardware Manual
The System Hardware Manual is provided for the system installer. This
manual provides detailed instructions for installing the Xen KSU, ETUs,
Multiline Terminals, and optional equipment.
Least Cost Routing Manual
This manual provides instructions to the service technician for programming
the customer site for least cost routing.
xvii