Function Timer Chart - NEC Xen IPK Programming Manual

Xen IPK
SECTION 5
FUNCTION TIMER
CHART
Timer
Pause Time
Selection
DP Interdigit Time
Selection
Hookflash Time
Selection
Hold Recall Timer
Selection
(Non-Exclusive
Hold)
Automatic Redial
Time Selection
Start Timer
Selection
CO/PBX Incoming
Ringing Alarm Time
Selection
Tie Line Delay
Ringing Timer
Selection
Station Transfer/
Camp-On Recall
Timer Selection
Trunk Queuing
Timeout Selection
CO/PBX Prepause
Timer Selection
Section 5, Function Timer Chart
The chart on the following pages provides a list of timers that can be
programmed in the system. The information is listed numerically by Memory
Block number. A brief definition and the timing value is given for each timer.
Table 1-3:
Memory
Definition
Block
Duration when no signal is being
1-1-00
sent to a CO/PBX line.
Minimum interval between dialling
1-1-01
signals in Dial Pulse dialling.
Timing of a CO/PBX hookflash
1-1-02
from the Recall key of a Multiline
Terminal or a Single Line
Telephone to the CO/PBX line.
Specify the time before a held
1-1-03
CO/PBX line recalls the station
that put that line on hold.
Defines the redial timing
1-1-04
parameters when automatic redial
is set to a busy CO/PBX number.
Specify the time for after dialling
1-1-05
and the start of call duration
display and Talk Start Timer.
Specify the time from receiving an
1-1-06
incoming CO/PBX call until the
ringing tone changes to a different
ringing tone level if the call is not
answered.
Specify the delay interval between
1-1-07
the time a telephone rings
(accessed by a ringing call in the
Tie/DID line) and the time other
telephones start ringing.
The time before a ring transferred
1-1-12
call recalls to the station that
transferred the call.
Specify the time queuing for a
1-1-37
CO/PBX line recalls before being
automatically cancelled.
Specify the pause time before
1-1-57
dialled digits are sent over a
CO/PBX line.

Function Timer Chart

Minimum
650/500 ms.
Programming Manual
Timing Value
Default
1 sec. 3 sec.
800/800 ms.
20 ms. 600 ms.
25 sec. 25 sec.
30 sec.
2 sec. 10 sec.
10 sec. No Limit
10 sec. No Limit
25 sec. 45 sec.
10 sec. 10 sec.
None 1 sec.
DRAFT 3
Maximum
3 sec.
800/800 ms.
5000 ms.
(5 sec.)
No Limit
60 sec.
70 sec.
No Limit
No Limit
No Limit
60 sec.
15 sec.
Chapter 1 – 521