Xen IPK
Trunk Group Outgoing
Priority Selection
General Description
Use this Memory Block to assign the Outgoing Priority for trunk access to each Trunk
Group. This is normally used with a Tie Line or K-CCIS network to reverse the search order
and reduce call collisions during trunk seizure
Applicable for IPK R2000 and above.
Display
Trunk Group No.
Data
(01~32)
No.
0 1 / 0 6 : P R I O R .
T I M E
Settings
LK1
LK2
H → L
L → H
High to Low
Low to High
Programming Procedures
1
Go off-line.
N
2 Press LK5 +
+
KF
3 Press the corresponding CO/PBX line key to change the Setting Data option.
N
4 Press
to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
Related Programming
M.B. Number
1-1-46~48
Access Code (1-, 2- or 3-Digit) Assignment
Function 201~232 – Route Advance Block 01~32
Function 401~416 – Closed Number Block 01~32
Function 601~604 – ACR Table 1~4
1-1-30
Route Advance Block Assignment
1-1-49
Networking Trunk Group/Route Advance Assignment
1-14-04
ACR Trunk Group to Route Number Assignment
N
This Memory Block should not be assigned (use default) for trunk groups with trunks belonging to an IAD(8)-
U( ) ETU used with IP (K-CCIS) or IP (K-CCIS) to NEAX (Point-to-Multipoint).
5-06, Trunk Group Outgoing Priority Selection
.
Setting
Title
Data
H > L
D I S P L A Y
LK3
LK4
LK5
2
3
4
to access the Memory Block.
P
to go back on-line.
LK6
LK7
Memory Block Name
Programming Manual
System Mode
5
Submode
—
Data No.
06
PC Programming
+ ALN
LK8
The shaded area indicates
the default setting.
DRAFT 3
Chapter 1 – 491
5-06