NEC Xen IPK Programming Manual page 411

Xen IPK
Programming Procedures
1 Go off-line.
N
2 Press LK3 + +
Use the dial pad to enter the time required.
3
Note: to move cursor left.
J
to move cursor right.
L
Setting Data (Allow): Class 1 to Class 4: 00 to 99 sec
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
3-63 DIT Tenant Assignment
3-64 DIT Holiday Mode Enable
3-65 DIT Night Mode Delay Answer Enable
4-71 Time Class Assignment for Telephone Mode (R2000 and above)
N
When the time is set to a value other than 0, call termination is treated as a normal incoming call and DIT termination is
performed after the time elapses. When 0 is selected, DIT call termination is performed immediately.
3-61, DIT Delay Answer Timer Selection
to access the Memory Block.
AE
(00 = Unlimited)
Default values:
Trunk 01~64 = 00 sec
Memory Block Name
Programming Manual
DRAFT 3
Chapter 1 – 391