Figure 1-1: Programming Flowchart - NEC Xen IPK Programming Manual

December 2004
2 – Chapter 1
Functions of an existing system are changed.
New Installation
Develop System
Data Sheet
Installation
Test System with
Default Values
System Data
Programming (Note 1)
TEST
Note 1: For new installations, system default values are assigned when the
power is turned on. Therefore, only program the system data to be
changed.
Note 2: For component replacements, program the relevant system data.
Note 3: For function changes, program the system data to be revised.

Figure 1-1: Programming Flowchart

2.1 Features of Programming
The following features are provided with Multiline Programming:
The system operates from default after initial power-up. The
technician needs to program only the parameters that change
from the default assignments.
System programming characters are displayed on the LCD of the
Multiline Terminal.
Several types of system programming can be entered at the
same time.
Data programmed for one telephone (e.g., Tenant Mode, CO/
PBX Line Mode, or Telephone Mode) can be copied to another
telephone.
Two Multiline Terminals can be used simultaneously for
programming. These terminals are connected to ports 01 and 02.
DRAFT 3
Existing System
Component
Replacement
Rewrite System
Data Sheet
Installation
System Data
Programming (Note 2)
TEST
Multiline Terminal Programming
NEC Business Solutions Ltd
Function
Change
Rewrite System
Data Sheet
System Data
Programming (Note 3)
TEST