Dti Trunk Type Assignment - NEC Xen IPK Programming Manual

Xen IPK

DTI Trunk Type Assignment

General Description
Use this Memory Block to assign the trunk type (CO/E&M Tie line/DID/ANI) four channels at
a time. Assignment to an individual channel is impossible
Applicable for R2000 and above
Display
DTI No. Data
(01~08) No.
0 1 / 0 7 T R K ( 1 )
T I M E
Settings
LK1 LK2
CO E&M
Programming Procedures
Go off-line.
1
Press LK1 + LK11 +
2 KG
3 Press the corresponding CO/PBX line
4-Channel Unit
Block
DTI
No.
No. 1
1 01~04
2 05~08
3 09~12
4 13~16
5 17~20
6 21~24
N
4 Press to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
Related Programming
M.B. Number
1-11-06 Signalling Selection
7-1 Card Interface Slot Assignment
N
1. A DTI-U( ) ETU must be assigned in the system to set this Memory Block.
2. When the default setting is changed to E&M or DID, the affected trunks are automatically reassigned to Trunk Group
00. When trunks 01 ~ 08 are affected, default line key assignment for all Multiline Terminals changes to Not Used and
must also be reassigned. Memory Block 3-14 resets to second dial.
1-11-07, DTI Trunk Type Assignment
.
Setting
Title Data
C O
D I S P L A Y
LK3 LK4 LK5
DID ANI
to access the Memory Block.
key to change the data option
DTI DTI
No. 2 No. 3~8
01~04 01~04
05~08 05~08
09~12 09~12
13~16 13~16
17~20 17~20
21~24 21~24
P
.
LK6 LK7
.
to go back on-line.
Memory Block Name
Programming Manual
1-11-07
System Mode
1
Submode
11
Data No.
07
PC Programming
+ AD
LK8
The shaded area indicates
the default setting.
DRAFT 3
Chapter 1 – 267