Lcr Class To Trunk Group Selection - NEC Xen IPK Programming Manual

Xen IPK
LCR Class to Trunk Group
Selection
General Description
Use this Memory Block per trunk group to specify the Least Cost Routing (LCR)/Automatic
Carrier Routing (ACR) Class. For systems connected using K-CCIS, the Electra Elite can
analyze incoming telephone numbers received from a distant system and use the LCR/ARS
assignments to route the call to its desired destination
Applicable for IPK R2000 and above.
Display
Trunk Group No. Data
(01~32) No.
0 1 / 0 4 : C L A S S
T I M E
Settings
LK1 LK2
0 1
Programming Procedures
Go off-line.
1
N
KD
2 Press LK5 + +
3 Press the corresponding CO/PBX line key to change the Setting Data option.
N
4 Press to write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
Related Programming
M.B. Number
3-70 CIC Number Assignment
1-1-05 Start Time Selection
1-1-46~48 Access Code (1-, 2- or 3-Digit) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection

5-04, LCR Class to Trunk Group Selection

Setting
Data
Title
0
D I S P L A Y
LK3 LK4 LK5
2 3 4
to access the Memory Block.
P
to go back on-line.
.
LK6 LK7
Memory Block Name
Programming Manual
System Mode
5
Submode
—
Data No.
04
PC Programming
+ AW
LK8
The shaded area indicates
the default setting.
DRAFT 3
Chapter 1 – 487
5-04