Apr Hookflash Selection - NEC Xen IPK Programming Manual

Xen IPK

APR Hookflash Selection

General Description
Use this Memory Block to allow/deny Hookflash for an Analogue Port Adapter (APR) on a
Multiline Terminal.
Display
Tel Port
Data
No.
No.
(01~CO)
0 1 / 5 9 : H K
T I M E
Settings
LK 1 LK 2
NO YS
LK 5 LK 6
Programming Procedures
Go off-line.
1
Press LK4 +
2 EI
3 Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data or Tel Port No.
R
– OR –
to go to next assigned Tel Port No.
Q
+1 to enter A for Port Numbers 100~109
Q
+2 to enter B for Port Numbers 110~119
Q
+3 to enter C for Port Number 120
Press the corresponding CO/PBX line key to change the setting data option.
4
N
5 Press to write the data and display Memory Block 4-1 for next Tel Port No.
6 Program the next Tel Port No. or press
Related Programming
M.B. Number
1-1-02 Hookflash Time Selection
1-3-02 SLT Hookflash Signal Selection
4-40 APR Ring Mode Assignment
4-93 DTMF/DP SLT Type Selection
N
Operation of SLT connected to APR is the same as the Single Line Telephone.
4-59, APR Hookflash Selection
Setting
Title
Data
F L S H N O
D I S P L A Y
LK 3 LK 4
LK 7 LK 8
to access the Memory Block.
P
To go back on-line.
The shaded area indicates
the default setting.
Memory Block Name
Programming Manual
4-59
System Mode
4
Submode
—
Data No.
59
PC Programming
+ BTM
DRAFT 3
Chapter 1 – 465