Calling Name Display Allow/Deny Selection - NEC Xen IPK Programming Manual

December 2004
Calling Name Display Allow/
Deny Selection
General Description
Use this Memory Block per Common Signalling Channel to allow or deny sending the
station name
.
Applicable for IPK R2000 and above.
Display
Data C-Channel
No. 1~4
1 0 : C C H 1
T I M E
Settings
LK1 LK2
NO YS
Programming Procedures
Go off-line.
1
Press LK1 + LK15 +
2 AK
3 Press the corresponding CO/PBX line key to change the option.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
1-15-11 Centralised Billing Allow/Deny Selection
DRAFT 3
310 – Chapter 1
Setting
Title
Data
N A M E N O
D I S P L A Y
LK3 LK4 LK5
to access the Memory Block.
LK6 LK7
Memory Block Name

Calling Name Display Allow/Deny Selection, 1-15-10

NEC Business Solutions Ltd
System Mode
1
Submode
15
Data No.
10
PC Programming
+ AW
LK8
The shaded area indicates
the default setting.
1-15-10