Trunk Digit Restriction - NEC Xen IPK Programming Manual

December 2004

Trunk Digit Restriction

General Description
Use this Memory Block to specify the maximum number of digits per station that can be dialled
while on any outside line.
Display
Tel Port No.
Data
(01~99)
No.
A0~C0
0 1 / 3 2 : D G
T I M E
Programming Procedures
1 Go off-line.
2 Press LK4 + CB to access the Memory Block.
3 Use the dial pad to enter Setting Data (00 ~ 99 digits).
Note: Use the following to enter data:
K ~ I to enter numeric data
R
to select next Tel Port No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
Refer to Section 6, Code Restriction in this chapter.
N
1. Code Restriction must be assigned before this feature is used.
2. Trunk Digit Restriction applies to all CO/PBX lines.
3. Tie Line Code Restriction must be assigned before this feature works on Tie lines.
4. Telephone ports A0~C0 are ports 100~120.
DRAFT 3
438 – Chapter 1
Setting
Title
Data
R E S T = 0 0
D I S P L A Y
Default Values
00 (No Limit)
Memory Block Name
NEC Business Solutions Ltd
4-32
System Mode
4
Submode
—
Data No.
32
PC Programming
+ BTT
Trunk Digit Restriction, 4-32