Intercom Ring Pattern Selection - NEC Xen IPK Programming Manual

Xen IPK
Intercom Ring Pattern
Selection
General Description
Use this Memory Block to select a ring pattern when intercom calls are made.
Display
Data
No.
1 9 : I C M
T I M E
Settings
(Page 1)
LK 1 LK 2
Tone Off Tone On
LK 5 LK 6
Pattern C Pattern D
(Page 2)
LK 1 LK 2
Pattern G Pattern H
LK 5 LK 6
Programming Procedures
1 Go off-line.
Press LK1 + L2 +
2 AI
Press the corresponding CO/PBX line key to change the data option.
3
Note: Use the following to enter data:
S
to go to the next page
T
to go to the previous page
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.

1-2-19, Intercom Ring Pattern Selection

Setting
Page
Title Data
P T N B | 1
D I S P L A Y
LK 3 LK 4
Pattern A Pattern B
LK 7 LK 8
Pattern E Pattern F
LK 3 LK 4
LK 7 LK 8
to access the Memory Block.
The shaded area indicates
the default setting.
Programming Manual
1-2-19
System Mode
1
Submode
2
Data No.
19
PC Programming
+BI
DRAFT 3
Chapter 1 – 137