Dit Night Mode Delay Answer Enable - NEC Xen IPK Programming Manual

Xen IPK
DIT Night Mode Delay
Answer Enable
General Description
This Memory Block is used to specify whether or not the DIT Delay Answer Timer shall apply to
CO/PBX calls received when the system is in Night Mode.
Display
CO/PBX
No.
Data
(01~64)
No.
1 1 / 6 4 :
T I M E
Settings
LK 1 LK 2
No Yes
LK 5 LK 6
Programming Procedures
1 Go off-line.
N
Press LK3 + +
2
Press the corresponding CO/PBX line key to change the data option.
3
Note: Use the following to enter data:
J to move the cursor left
L
to move the cursor right
R
to go to the next CO/PBX Line No.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
3-62 DIT Delay Answer Timer Selection
N
1. The DIT Delay Answer Time specified in MB , 3-62 shall apply for this purpose.
2. If set to YES, incoming CO/PBX calls during Night Mode will ring for the duration specified in MB , 3-62 before
changing to DIT status.
3. If set to NO, incoming CO/PBX calls during Night Mode will immediately change to DIT status regardless of the setting
in MB , 3-52.
4. This setting only applies to those CO/PBX lines assigned with the DIT facility in MB , 3-44 and MB , 3-45.

3-64, DIT Night Mode Delay Answer Enable

Setting
Title
Data
N T M O D N 0
D I S P L A Y
LK 3 LK 4
The shaded area indicates
the default setting.
LK 7 LK 8
to access the Memory Block.
DD
Memory Block Name
Programming Manual
System Mode
3
Submode
—
Data No.
64
PC Programming
+ BCT
DRAFT 3
Chapter 1 – 395
3-64