Caller Id Display Assignment For System Mode - NEC Xen IPK Programming Manual

Xen IPK
Caller ID Display Assignment
for System Mode
General Description
Use this Memory Block to assign up to 15 Multiline Terminals to display Caller ID Indication for
normal incoming CO/PBX calls or CO/PBX calls ringing a Call Arrival (CAR) key.
This memory block is removed with IPK R2000 and above.
Display
Data
No.
7 8 : C A L L I D
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 + GH
3 Use the dial pad to enter Entry No.1 or 2 and Tel Port No.
Note: Use the following to enter data:
J to move the cursor left
L
to move the cursor right
K ~ I to enter numeric data
N
4 Press to write the data and advance to the next Entry No. After data for Entry No. 2 is entered, press
total of 15 entries can be made.
P
Press to go back on-line.
5
Related Programming
No related programming is necessary for this Memory Block.
N
1. To display Caller ID Indication for normal incoming and CAR incoming calls, Caller ID Indication and Ring Assignment
must be assigned for the terminal in system programming.
2. Fifteen Multiline Terminals can be assigned system-wide to display Caller ID.
3. A sixteenth terminal can be assigned to display Caller ID using another Memory Block.

1-1-78, Caller ID Display Assignment for System Mode

Entry Tel Port No.
Title No. (00~99 A0~A9
1~7 1~15 B0~B9 CO)
1 = 0 0
D I S P L A Y
to access the Memory Block.
Programming Manual
1-1-78
System Mode
Submode
Data No.
PC Programming
Default Values
Not specified
DRAFT 3
1
1
78
+ AI
N
again. A
Chapter 1 – 119