Common Signal Channel Assignment - NEC Xen IPK Programming Manual

Xen IPK
Common Signal Channel
Assignment
General Description
Use this Memory Block to assign a T1 Trunk to be a Common Signalling Channel
Applicable for IPK R2000 and above.
Display
Data
Title
No.
0 2 : C S C
T I M E
Programming Procedures
Go off-line.
1
2 Press LK1 + LK15 +
3 Use dial pad keys to select Table number
Note: Use the following pad keys to enter Setting Data:
J
to move cursor left.
L
to move cursor right.
K ~ I to enter numeric data.
N
Press to write the data.
4
P
Press to go back on-line.
5
Related Programming
M.B. Number
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
1-15-10 Calling Name Display Allow/Deny Selection
1-15-11 Centralised Billing Allow/Deny Selection

1-15-02, Common Signal Channel Assignment

C-Channel Setting
1~4 Data
1 = C O 0 0
D I S P L A Y
KB to access the Memory Block.
.
Default Values :
00
Memory Block Name
Programming Manual
1-15-02
System Mode
1
Submode
15
Data No.
02
PC Programming
+ AW
DRAFT 3
Chapter 1 – 293