Start Timer Selection - NEC Xen IPK Programming Manual

Xen IPK

Start Timer Selection

General Description
Use this Memory Block to specify the time needed after dialling before the system starts the
Elapsed Call Timer, SMDR Start Timer, and Talk Start Timer.
With IPK R2000 and above, this memory block allows flexible entries and has four classes.
For R2000 only.
Display
Data
No.
0 5 : C A L L S T A R T
T I M E
Settings
LK 1 LK 2
10 sec. 20 sec.
LK 5 LK 6
50 sec. 60 sec.
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 + KE
3 Press the corresponding CO/PBX line key to change the data option.
N
4 Press to write the data.
P
Press to go back on-line.
5
For R2000 and above.
Display
Data
No.
0 5 : S T A R T
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 + KE
3 Use the dial pad to enter the time required.
Note: J to move cursor left.
to move cursor right.
L
Setting Data (Allow): Class 1 to Class 4: 00 to 99 sec
1-1-05, Start Timer Selection
Setting
Title Data
1 0 s
D I S P L A Y
LK 3 LK 4
30 sec. 40 sec.
The shaded area indicates
the default setting.
LK 7 LK 8
70 sec. 2 sec.
to access the Memory Block.
Setting
Title Class Data
X = 0 2 s
D I S P L A Y
to access the Memory Block.
00 = No Limit
1-1-05
Default values:
Class 1 to Class 4 = 60 secs
DRAFT 3
Programming Manual
System Mode
1
Submode
1
Data No.
05
PC Programming
+ BM
Chapter 1 – 37