Automatic Release Selection - NEC Xen IPK Programming Manual

Xen IPK

Automatic Release Selection

General Description
This Memory Block specifies whether or not the system is to release a trunk used to make an
outgoing call when the called party hangs. Selecting Yes will result in the system disconnecting
the trunk upon the outside party hanging up. Selecting No will result in the trunk being held upon
the outside party hanging up, the trunk only being released when the KTS extension hangs up.
Display
CO/PBX
No.
Data
(01~64)
No.
0 1 / 3 9 : A U T O R L S
T I M E
Settings
LK1 LK2
No Yes
LK5 LK5
Programming Procedures
Go off-line.
1
N
2 Press LK3 + +
3 Press the corresponding CO/PBX line key to change the data option
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
The attendant telephone position must dial an Access Code to activate this feature.
3-39, Automatic Release Selection
Setting
Title
= Y S
D I S P L A Y
LK3 LK4
The shaded area indicates
the default setting.
LK7 LK8
CI to access the Memory Block.
Data
Programming Manual
System Mode
3
Submode
—
Data No.
39
PC Programming
+ AU
DRAFT 3
Chapter 1 – 379
3-39