Centralised Blf Send Time Assignment - NEC Xen IPK Programming Manual

December 2004
Centralised BLF Send Time
Assignment
General Description
Use this Memory Block to assign the time interval for sending BLF information across the K-
CCIS Network.
System Software R2000 or higher is required.
Display
Data
No.
1 7 : S E N D
T I M E
Settings
LK1 LK2
4 Seconds 4 Seconds 4 Seconds
(04s) (08s)
Programming Procedures
1 Go off-line.
2 Press LK1 + LK15 + AG
3 Press corresponding CO/PBX line key to change the Setting Data option.
N
4 Press to write the data, and display the next Memory Block.
5 Program the next Memory Block or p
Related Programming
M.B. Number
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
DRAFT 3
324 – Chapter 1
Setting
Title Data
T I M E 0 4 s
D I S P L A Y
LK3 LK4 LK5
4 Seconds
(12s) (16s)
to access the Memory Block.
P
ress to go back on-line.
LK6 LK7
Memory Block Name

Centralised BLF Send Time Assignment, 1-15-17

NEC Business Solutions Ltd
System Mode
1
Submode
15
Data No.
17
PC Programming
+ AW
LK8
The shaded area indicates
the default setting.
1-15-17