Dial-In Tenant Incoming Limit Assignment - NEC Xen IPK Programming Manual

December 2004
Dial-In Tenant Incoming
Limit Assignment
General Description
Use this Memory Block to assign names for telephone stations.
Display
Tel Port
No.
Data
(00~47)
No.
A0~C0
0 0 / 0 9 :
T I M E
Programming Procedures
1 Go off-line.
2 Press LK2 + K I
3 Use the dial pad to enter data.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter numeric data
R
to go to next Tenant.
Setting Data: 0 = No Limit
1~64 = Number of effective incoming
N
Press to write the data.
4
After entering all data, press
5
P
Press to go back on-line.
6
Related Programming
M.B. Number
2-01 Trunk to Tenant Assignment
N
Only DID incoming calls are limited. Outgoing calls, Internal (ICM) calls, and normal incoming calls are not limited.
DRAFT 3
338 – Chapter 1
Title
L I M I T
D I S P L A Y
to access the Memory Block.
N
Data
0 0
Memory Block Name

Dial-In Tenant Incoming Limit Assignment, 2-09

NEC Business Solutions Ltd
System Mode
Submode
Data No.
PC Programming
Default Values
No Limit = 0
2-09
2
—
09
+ BN