Automated Attendant Message To Tenant Assignment - NEC Xen IPK Programming Manual

Xen IPK
Automated Attendant Message
to Tenant Assignment
General Description
Use this Memory Block to assign Automated Attendant Messages to Tenant.
Display
Data
No.
Title
1 2 : A A
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK4 +
AB
Use the dial pad to enter data.
3
Note: Use the following to enter data:
A ~ H to enter Automated Attendant message number.
K ~ I to enter Tenant Number.
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
Refer to Chapter 2, Guide to Feature Programming.
N
If a tenant is not assigned to a specific automated message, the Automated Attendant sends the message assigned in
Memory Block , 1-4-11 , Automated Attendant Message Day Night Mode Selection.

1-4-12, Automated Attendant Message to Tenant Assignment

A.A.
No.
Setting
1~8
Data
1 T N A T = 0 0
D I S P L A Y
to access the Memory Block.
Memory Block Name
Programming Manual
System Mode
1
Submode
4
Data No.
12
PC Programming
+ AU
Default Values
All Automated Attendant Messages:
Tenant No. 00
DRAFT 3
Chapter 1 – 177
1-4-12