Did Digit Conversion Table & Dnis Assignment - NEC Xen IPK Programming Manual

December 2004
DID Digit Conversion Table
& DNIS Assignment
General Description
Up to 200 incoming DID numbers can be assigned individually to ring at preassigned extension
numbers on a day mode and night mode basis. This Memory Block applies to the DID number
after it is modified by Memory Block 5-00.
Display
Data
Digits
No.
Received
2 2 :
DNIS ASSIGNMENT
Settings
LK 1 LK 2
TEL=T TENANT=TN
LK 5 LK 6
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 + BB
3 Enter the data using the dial pad.
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
K I
~ to enter numeric data
S
to change DNIS, then use
each indial number (name applies to both day and night mode). Refer to
"System Data Input," on page 541
Q
to change between Day and Night table
U
to clear all data
N
Press to write the data.
4
P
5 Press to go back on-line.
Related Programming
M.B. Number
1-1-20 DID Digit Length Selection
1-1-21 DID Digit Conversion Assignment
1-1-23 DID Forward Station Number for Busy Station or Undefined Digit
4-01 CO/PBX Ring Assignment (Day Mode)
DRAFT 3
56 – Chapter 1
Title Destination
D Y = T
LK 3 LK 4
The shaded area indicates
the default setting.
LK 7 LK 8
to access the Memory Block.
K I to enter an alphanumeric name for
~
for details on character entry.
Table 1,
Memory Block Name
DID Digit Conversion Table & DNIS Assignment, 1-1-22
NEC Business Solutions Ltd
1-1-22
System Mode
1
Submode
1
Data No.
22
PC Programming
+ ALN
Default Values
Not Assigned.
Setting Data
TEL = LK1 = Extension No.
00~99
000~999
0000~9999
TENANT = LK2 = 00~47