Xen IPK
CO/PBX Incoming Ringing
Alarm Time Selection
General Description
Use this Memory Block to specify the time interval between the time a CO/PBX call is detected
and the time the ringing tone changes to a higher pitch when the call is not answered. If No Limit
is selected, the ringing tone does not change.
With IPK R2000 and above, this memory block allows flexible entries and has four classes.
For R2000 only.
Display
Data
No.
0 6 : R I N G
T I M E
Settings
LK 1
LK 2
10 sec.
20 sec.
LK 5
LK 6
For R2000 and above.
Display
Data
No.
0 6 : R I N G
T I M E
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 +
KF
3
Use the dial pad to enter the time required.
Note:
to move cursor left.
J
to move cursor right.
L
Setting Data (Allow):
N
4
Press
to write the data.
P
5
Press
to go back on-line.
1-1-06, CO/PBX Incoming Ringing Alarm Time Selection
Setting
Title
Data
∞
A L M
D I S P L A Y
LK 3
LK 4
∞
30 sec.
The shaded area indicates the
default setting.
LK 7
LK 8
Setting
Title
Data
A L M
0 0 0 s
D I S P L A Y
to access the Memory Block.
000 to 255 sec
000 = No Limit
1-1-06
Default values:
Class 1 to Class 4 = 60 secs
DRAFT 3
Programming Manual
System Mode
1
Submode
1
Data No.
06
PC Programming
+ BM
Chapter 1 – 39