Acr Feature Allow/Deny Selection - NEC Xen IPK Programming Manual

Xen IPK
ACR Feature Allow/Deny
Selection
General Description
Use this Memory Block to specify whether or not ACR is system wide.
Display
Data
No. Title
0 0 : A C R
T I M E
Settings
LK 1 LK 2
NO YES
(Allow)
(Deny)
LK 5 LK 6
Programming Procedures
1 Go off-line.
2 Press LK1 + LK14 to access the Memory Block.
Press the corresponding CO/PBX line key to change the Setting Data option.
3
N
4 Press to write the data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
3-03 Trunk-to-Trunk Group Assignment
4-40 LCR Class Selection
1-8-08 Class of Service (Station) Feature Selection 2
1-14-01 ACR Dialling Assignment
1-14-01 ACR Dialled Number Dial Allow/Deny Selection
1-14-03 ACR Trunk Group to Route Number Assignment
1-14-05 ACR Digit Add Assignment
1-14-02 ACR Route Table Number Assignment
1-14-04 ACR Digit Delete Assignment
*When ACR is set to Allow in this MB, LCR stored on the MIF-L will stop functioning.

1-14-00, ACR Feature Allow/Deny Selection

Setting
Data
N O
D I S P L A Y
LK 3 LK 4
The shaded selection
is the default.
LK 7 LK 8
Memory Block Name
Programming Manual
1-14-00
System Mode
1
Submode
14
Data No.
00
PC Programming
+ AO
DRAFT 3
Chapter 1 – 281