NEC Xen IPK Programming Manual page 42

December 2004
LK 1 System Mode (Continued)
LK 15 ???
Data
Memory Block Name
No.
18 Centralised BLF Receive Extension
Number Assignment
LK 2 Tenant Mode
Data
Memory Block Name
No.
01 Trunk to Tenant Assignment
05 Line Key Selection
06 Line Key Selection for Tenant Mode
07 System Speed Dial Display Assignment
08 ECR Relay to Tenant Assignment
09 Dial-In Tenant Incoming Limit Assignment
LK 3 CO/PBX Line Mode
Data
Memory Block Name
No.
00 Trunk Name/Number Assignment
02 ISDN Dial-Out Sending Selection
03 Trunk-to-Trunk Group Assignment
04 Trunk-to-Trunk Transfer Yes/No Selection
05 Trunk Incoming Answer Mode Selection
06 Automatic Tandem Trunk Assignment
07 CO/PBX Ringing Variation Selection
11 CO External Source Selection
12 CO Hold Melody Selection (CO)
22 – Chapter 1
Default Value
Default Value
Refer to Trunk to Tenant Assignment on page 1-329.
Telephone Mode
Refer to Line Key Selection for Tenant Mode on page 1-332.
All Speed Dial
Confirmation Allowed
All Tenants - No
Assignment
No Limit = 0
Default Value
All Trunks = Blank (ASCII
Entry)
Out and In
Refer to Trunk-to-Trunk Group Assignment on page 1-341.
Yes
Normal
Not Specified
Medium (M)
Not Specified
Not Specified
DRAFT 3
NEC Business Solutions Ltd
Programming Values
Programming Values
Telephone Mode
Tenant-Wide Mode
No (Not Allowed)
Yes (Allowed)
Assigned or Not Assigned - Ext Tone Relay
1~4 and Night Chime per Tenant
00~47 tenants (each can be assigned a limit
dependant on max. lines available)
Programming Values
Maximum of 13 characters/numbers
Out and In
In
No, Yes
Normal
Automatic Trunk-to-Trunk Transfer
Automated Attendant/DISA
CO 01~64
Low (L)
Medium (M)
High (H)
Trunks 1~64
Trunks 1~64
Multiline Terminal Programming