NEC Xen IPK Programming Manual page 27

Xen IPK
Programming Manual
2.5.3 Entering Programming Mode
To program information in the system, the following digital
Multiline Terminals can be used as programming stations.
Two stations, ports 01 and 02, are automatically assigned as
programming stations.
DTU-16D-1A (BK)/(WH) TEL
DTU-32D-1A (BK)/(WH) TEL
DTR-8D-1A( ) TEL
DTR-16D-1A( ) TEL
DTR-32D-1A( ) TEL
To enter programming mode, the station must be off-line. To
go off-line:
T
1. Press
U
2. Press
3. Dial ,
L K
LCD indicates program mode is now active.
While off-line, the programming terminal cannot be signalled
by any system station. Off-line mode does not timeout.
2.5.4 Page Switching
In Memory Block 1-1-18 (System Speed Dial Restriction by
Tenant) tenant numbers 00~07 are assigned to Flexible Line
keys on the first page. Tenant number 08~15 are assigned to
the Flexible Line keys on the second page. The tenant
number corresponding to Flexible Line key 1 of the current
page is displayed on the right side of the display.
During system programming, a value (data) is assigned to
each Flexible Line key. When there are more values than
Flexible Line keys, value assignments are displayed on
additional pages. The associated data can be entered on
that page. The page number is displayed at the right side of
the LCD.
Figure 1-3 Page Switching for 16-Key and 24-Key multiline
Terminals shows an example of CO/PBX line keys on each
page and their corresponding tenant numbers. In all cases
each page is represented by eight line keys.
DRAFT 3
.
.
, and in sequence. The Multiline Terminal
J
P R O G R A M M O D E
T I M E D I S P L A Y
Programming Manual
Chapter 1 – 7