Link Reconnect Allow/Deny Selection - NEC Xen IPK Programming Manual

December 2004
Link Reconnect Allow/Deny
Selection
General Description
Use this Memory Block to specify the number of digits to be collected by the system before
the message is sent to the network
Applicable for IPK R2000 and above.
Display
Data
No.
0 8 : M A X D G T
T I M E
Settings
LK1 LK2
NO YS
(Deny) (Allow)
Programming Procedures
1 Go off-line.
2 Press LK1 + LK15 + KH
3 Press the corresponding CO/PBX line key to change the option.
N
4 Press to write the data.
P
Press to go back on-line.
5
Related Programming
M.B. Number
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
1-15-10 Calling Name Display Allow/Deny Selection
DRAFT 3
306 – Chapter 1
.
Route Setting
Title
01~32 Data
0 1 = 2 4
D I S P L A Y
LK3 LK4
to access the Memory Block.
LK5 LK6 LK7
Memory Block Name

Link Reconnect Allow/Deny Selection, 1-15-08

NEC Business Solutions Ltd
System Mode
1
Submode
15
Data No.
08
PC Programming
+ AW
LK8
The shaded area indicates
the default setting.
1-15-08