Networking Trunk Group/Route Advance Assignment - NEC Xen IPK Programming Manual

December 2004
Networking Trunk Group/
Route Advance Assignment
General Description
Use this Memory Block to assign the function number of the Trunk Group to be used to network
an Xen system to another system by Tie lines or CO/PBX/CTX lines.
Display
Closed
Data Number Block
No. 01~16
4 9 : 0 1 = R T
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 + DI
3 Use dial pad to enter the Function Number of the Trunk Group or the Route Advance
Block.
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
K I
~ to enter numeric data
U
to clear all data
N
4 Press to write selected data.
P
Press to go back on-line.
5
Related Programming
M.B. Number
1-1-30 Route Advance Block Assignment
3-03 Trunk-to-Trunk Group Assignment
1-1-50 CO/PBX Outgoing Digit Add Assignment
N
Function Number 101
respectively) is assigned to Closed Number blocks.
DRAFT 3
84 – Chapter 1
Enter
Function
No.
D I S P L A Y
to access the Memory Block.
~
132 (Trunk Group 1
Memory Block Name
~
32, respectively) or 201

Networking Trunk Group/Route Advance Assignment, 1-1-49

NEC Business Solutions Ltd
1-1-49
System Mode
1
Submode
1
Data No.
49
PC Programming
+ BCS
Default Values
Not Specified
~
216 (Route Advance Block 1
~
16,