Centralised Day/Night Switching For Remote Office Assignment - NEC Xen IPK Programming Manual

Hide thumbs Also See for Xen IPK:
Table of Contents

Advertisement

December 2004
Centralised Day/Night
Switching for Remote Office
Assignment
General Description
Use this Memory Block to assign the Xen IPK to switch Day/Night mode when it receives
the command from a main office
Applicable for IPK R2000 and above.
Display
Data
No.
1 3 : C E N
T I M E
Settings
LK1
LK2
NO
YS
(Deny)
(Allow)
Programming Procedures
1
Go off-line.
2
Press LK1 + LK15 +
AC
3
Press the corresponding CO/PBX line key to change the Setting Data option.
N
Press
to write the data, and display the next Memory Block.
4
5 Program the next Memory Block or p
Related Programming
M.B. Number
7-1
Card Interface Slot Assignment
7-3-01
MIF (LCR) Assignment
7-3-02
MIF (SMDR) Assignment
1-15-00
K-CCIS Main/Remote Office Selection
1-15-02
Common Signal Channel Assignment
1-15-03
Originating Point Code Assignment
1-15-04
Destination Point Code Assignment
1-15-05
Destination Point Code Transfer Assignment
1-15-06
Originating Office Code Number Assignment
1-15-07
K-CCIS Message Response Timeout Assignment
1-15-08
Link Reconnect Allow/Deny Selection
DRAFT 3
316 – Chapter 1
.
Setting
Title
Data
D / N
N O
D I S P L A Y
LK3
LK4
LK5
to access the Memory Block.
P
ress
to go back on-line.

Centralised Day/Night Switching for Remote Office Assignment, 1-15-13

LK6
LK7
Memory Block Name
NEC Business Solutions Ltd
System Mode
1
Submode
15
Data No.
13
PC Programming
+ AW
LK8
The shaded area indicates
the default setting.
1-15-13

Advertisement

Table of Contents
loading

Table of Contents