Xen IPK
Second Initialisation
General Description
Use this Memory Block to initialise all the system hardware. All system software and user
programming are retained after the Second Initialisation.
Display
C P U
R E S E T
T I M E
Programming Procedures
1
Go off-line.
2
Press LK8 + LK8 +
HHKK
3
When the system display prompt indicates CPU RESET?, the first four CO/PBX lines light red.
WWWW
Red
Red
Red
N
Press
to begin the initialisation process.
4
P
Press
to go back on-line.
5
Related Programming
No related programming is necessary for this Memory Block.
N
If VMS, FMS, ACD and/or IPT cards installed in the system, please ensure all cards have completed their startup
sequence before performing a second initialisation.
These cards are considered fully 'started up' about 5 minutes after power is applied.
8-8-8800, Second Initialisation
?
D I S P L A Y
to access the Memory Block.
Red
IMPORTANT
Programming Manual
8-8-8800
System Mode
8
CO-Line
8
Data No.
8800
PC Programming
+ CI
DRAFT 3
Chapter 1 – 517