Co/Pbx Outgoing Digit Add Assignment - NEC Xen IPK Programming Manual

Xen IPK
CO/PBX Outgoing Digit Add
Assignment
General Description
Use this Memory Block to specify up to 10 additional digits when a trunk in the Trunk Group or
Route Advance block assigned in Memory Block 1-1-49 Networking Trunk Group/Route Advance
Assignment is seized, and a number is dialled.
Display
Closed
Data Number Block
No. 01~16
5 0 : 0 1 =
T I M E
Programming Procedures
1 Go off-line.
2 Press LK1 + LK1 + EK
3 Use dial pad to enter digits to be added.
Note: Use the following to enter data:
J
to move the cursor left
L to move the cursor right
K I to enter numeric data
~
U
to clear all data
Q
+ J to enter *
Q
L
+ to enter #
N
4 Press to write selected data.
P
5 Press to go back on-line.
Related Programming
M.B. Number
1-1-46 Access Code (3-Digit) Assignment
1-1-49 Networking Trunk Group/Route Advance Assignment

1-1-50, CO/PBX Outgoing Digit Add Assignment

Add Digit
10 Max. (0~9, *, #)
D I S P L A Y
to access the Memory Block.
Memory Block Name
Programming Manual
1-1-50
System Mode
1
Submode
1
Data No.
50
PC Programming
+ BCS
Default Values
Not Specified
DRAFT 3
Chapter 1 – 85