NEC Xen IPK Programming Manual page 546

December 2004
Memory
Timer
Tie Line Length of
Delay Signal
Selection
Tie Line Incoming
Interdigit Timeout
Selection
Tie Line Wink/Delay
Signal Detect
Timeout Selection
Disconnect
Recognition Time
Selection
DIT Delay Answer
Timer Selection
DRAFT 3
526 – Chapter 1
Function Timer Chart (Continued)
Table 1-3:
Definition
Block
Specify the time a delay pulse is
3-22
sent to another system.
Specify the maximum time during
3-24
the incoming call detection
process. If an address signal is not
received within a specified time,
an error tone is returned to the
other system.
Specify the maximum time for
3-25
receiving an acknowledgment
signal from a distant system
before sending a busy tone.
Specify a minimum time for a
3-33
disconnected circuit to be
accessed again.
This Memory Block is used to
3-61
specify the time and incoming CO/
PBX call will ring before changing
to DIT.
NEC Business Solutions Ltd
Timing Value
Minimum Default
0 ms. 300 ms.
1 sec. 6 sec.
1 sec. 7 sec.
0 sec. 0.3 sec
0 sec. 5 sec.
Section 5, Function Timer Chart
Maximum
4500 ms.
No Limit
No Limit
1.5 sec.
60 sec.